BioGuard® Water Balance, Conditioning & Accessory Products
BioGuard®. Guarding more than your pool.

For POOL use only.  DO NOT use in spas or hot tubs.
 

BioGuard® Balance Pak 200 pH Increaser safely & effectively increases the pH in your swimming pool.  No binders or fillers, just 100% pure sodium carbonate.

When pH is low, the pool water becomes very aggressive and corrosive damaging pool parts & surfaces. 

Low pH also causes the sanitizer to be used faster therefore consuming more of your chlorine or bromine.

Good water balance is essential - you can watch the Video here!

Excellent for use in all pools.  Swimmers may use pool only 15 minutes after application! 

No Pre-mixing required!

Application:
Read & follow all label instructions. When pool is not in use, broadcast 1 lb. Per 10,000 gals directly into the deep end of the pool with the pump running. 

Do not add through skimmer. 

Allow water to re-circulate 2 to 3 hours, retest, repeat treatment to adjust pH UP to 7.4 - 7.6.

Use as needed. 
Pump must run 8 -12 hours daily for best results. 

Sizes Available:

NOTE:  Avoid physical contact with product.  Follow all safety information on label instructions.  Open ONLY in WELL VENTILATED AREAS.  Avoid breathing fumes.  Store in a cool, dry place.  Keep out of the reach of children.

 

											ABOUT TRUST ONLINE
Returns		Shipping		Privacy & Policies		Recycling		Contact Us		Site Map
Copyright ©, Par Inc. of Conn., Par Pool & Spa, 2000 - 2012. All international rights reserved.