BioGuard®
Stain Remover Removes Stains caused by Metals
A specially
formulated blend of 3 concentrated, granular acids, allowing a wide spectrum of
stain removal with one product.
May be used in ALL POOLS treated with chlorine, bromine or biguanide.
Application: Read & follow all label instructions.
Adjust chlorine to less than 1.0 ppm.
Pre-dissolve 1.25 lb Stain Remover (for
fresh, mild stains; severe, older stains should increase dosage to 2.0 lb.) per 10,000 gals.
in a plastic bucket of 4 gallons of water.
Pour into pool & allow to
circulate for 1 hour.
After 1 hour, apply 1 quart of Pool Magnet Plus (use
SoftSwim Stain Control in biguanide pools) per 10,000 gals., & circulate 4
to 8 hours.
Apply
BioGuard Sparkle Up following the label instructions.
Continue
to circulate for 24 hours. Remove Sparkle Up from filter (BACKWASH OR
CLEAN FILTER).
Test pool
water & readjust water balance. Do not use when chlorine is higher than 1.0 ppm.
SORRY, THIS PRODUCT IS NO LONGER
AVAILABLE.
WE RECOMMEND
JACK'S MAGIC METAL & STAIN CONTROL PRODUCTS.
|